802 is not listed there but the cable for any of the other Sinumerik machines should be the same. The page shows 2 cables. I'd suggest Cable#2.
Settings in the 802 are quite simple. baud rate same as easyDnc. 7bits even parity. In easy Dnc set the Mode to none or auto.
That should do it.
By: Guest
Posted on: Nov 28 2013 at 10:55:28 AM
Cable schemes on dncsetup are PC(9 pin)-CNC(25 pin). Our CNC has only 9 pin output. What cable scheme should we use in such case?
By: Guest
Posted on: Nov 28 2013 at 08:10:11 PM
If you connect directly to the X2 connector inside the machine on the back of the control system then the cable will be a simple crossover like this.
2 - 3
3 - 2
4 - 6
5 - 5
6 - 4
7 - 8
8 - 7
But if the machine assembler has fitted an external RS232 port (connected internally to X2) then you should just check that the internal cable is 1 to 1 etc.
Reply - add a comment to this topic.
You may enter letters, numbers and standard punctuation only. HTML and other scripts/tags will be rejected.
