Hi i just got a 1996 haas vf6
Does anyone know the remo dnc settings please i thought they were ok but the computer tries to dump the massive program with no pauses so i get overflow
What is the best thing to do
Please help
By: Dave
Posted on: Nov 17 2017 at 11:21:57 PM
And do ì need to alter anything on tge haas controller if so what and where
By: Guest
Posted on: Nov 18 2017 at 09:59:17 PM
If the program goes in to the cnc but goes in too fast causing buffer overflow then i think we can assume baud rate etc are all correct.
Make sure flow control is enabled. Thats xon/xoff in the cnc parameters. Also make sure that xonxoff is enabled in the dnc software.
If it still overflows maybe consider lowering the baud rate. (Set the same baud rate in the cnc and in the dnc software).
Or increase the block delay in the dnc software setup.
Does your haas have an xmodem option? If it does then try that.
By: Guest
Posted on: Apr 16 2018 at 06:48:30 PM
I use the Cimco Edit V6 software. How to change the block delay?
By: Support
Posted on: Apr 17 2018 at 04:49:10 AM
I'm very sorry. Cimco Edit is not our product. I've never used that product so I just don't know. Take a look in the setup window - you might see a setting for Block Delay. Alternatively just try a lower baud rate or, if Cimco has an XModem option try that.
Lower baud rate or XModem should remove the necessity of a block delay if cimco doesn't have that.
But, as I said, Cimco isn't our product so I just don't know how to configure it. Sorry.
Reply - add a comment to this topic.
You may enter letters, numbers and standard punctuation only. HTML and other scripts/tags will be rejected.
