Fanuc oi-TC - an active topic on the DNC Software support forum


Topic: Fanuc oi-TC

By: Guest

Posted on: Jul 10 2018 at 12:46:54 PM

Does your software support this controller?

By: Guest

Posted on: Jul 12 2018 at 09:38:34 AM

All fanuc machines should be supported. They're pretty basic machines. Download the software. Go to setup and set it to Mode = 'Fanuc' or 'Auto'. Set the baud rate, databits etc as per the CNC and it should work on any fanuc.

For cable diagrams and parameters etc

Try this page [Fanuc]

Reply - add a comment to this topic.

You may enter letters, numbers and standard punctuation only. HTML and other scripts/tags will be rejected.

Topic: Fanuc oi-TC