I am sending programs to an Okuma lathe and every other line is blank. I had to install a new hard drive in the PC then re-install EasyDNC and thought I had the settings correct. Is there something I am missing. I am sure it is probably simple.
By: Guest
Posted on: Mar 3 2014 at 09:01:45 PM
In easydnc setup look at the end of block. If it something like CRLFLF then change it to CRLF
If its already CRLF then change it to CR or LF on its own.
By: Victor Biedrycki
Posted on: Mar 4 2014 at 04:44:11 PM
I set it to Ignore and that seemed to fix the problem... Thanks
Reply - add a comment to this topic.
You may enter letters, numbers and standard punctuation only. HTML and other scripts/tags will be rejected.
